Crawler shot blasting machine a castings, forgings and round spring bearing surface cleaning strengthening new cleaning equipment. It can clean the workpiece weight, size, volume, productivity, artificial, mechanical or automatic feeding. Tumbling, the workpiece in the blast chamber head consisting of shot blasting chamber by the belt, and two annular tank is made of a high wear-resistant material made of conveyor belt mounted on the guide bar, thus ensuring all surfaces of the workpiece are exposed and flipped when excessive collision does not occur. Workers in the operation of the crawler Abrator should strictly abide by the utility:

1 any of the operating personnel must be of the manual as well as the performance of the works and methods of operation, lubrication comprehensive understanding in order to carry out the operation;
The projectile (200kg) have joined the chamber body, and then into the workpiece, close the feed door, ready to drive;
The 3 start precipitators fan;
4 turn button start: hoist, shot blasting for the pill's gate and began clean-up work. After cleaning, turn the button off: pill for gates, shot blasting, hoist precipitator fan motor cleaning and then start rapping, rapping after a certain period of time to stop;
5 shot blasting is completely stopped, open the feeding door, hanging out of the tooling and the workpiece.
6 In case of emergency, press the emergency stop button, the machine immediately stop all work;
7 all of the work has been completed, should be promptly close the precipitator;
8 in the ventilation and dust removal system, equipped with two butterfly valves, two butterfly valves adjusted according to the situation, can be a good separation;
9 blast wheel directional sets of adjustments: the directed sets the adjustment can be with reference to the schematic diagram shown in Figure adjustment projectile diffusion angle increases due to directional liner wear during use, causing the guard shot blasting and clean room wear accelerated. The orientation sleeve wear more than 10 mm should be replaced with new sets of orientation (opening direction with an angle of 45 ° horizontal lines).
10 should be regularly cleared the the dust precipitator dust box below, to prevent blocking dust exhaust pipe impact dust effects;
11 should always clean the screen under the debris clean up the bottom of the chamber, and the separator funnel;
12 should be kept clean equipment around the projectile, to prevent slipping wounding;
13 should always check the track hoist the belt whether the deviation in the cleaning chamber, so as not to damage the belt;
14 prohibit open blast wheel did not completely stop feeding door, to prevent any accidents.